Samsung Tab S3 SM-T825 Binary U3 Combination File

Samsung Tab S3 SM-T825 Binary U3 Combination File

COMBINATION_FA70_T825XXU3ASE1

Samsung Tab S3 SM-T825 Combination File

How to Flash

1. Download the relevant USB driver for your Samsung device.
2. Download the flash tool Odin on your phone.
3. Now, download the relevant ADB Enable File for your device.
4. Open the Odin software then choose ADB Enable File in “AP” from the Box.
5. Turn on USB debugging mode on your phone.
6. Now, connect your mobile and computer with a USB cable.
7. Open the ADB Enable tool and click on the start. After that, your device will start rebooting.
8. Disconnect the USB cable.
9. Select language English when your phone turns on. After that, click next.
10. Now turn on Wi-Fi or mobile data.
11. After that, agree on the agreements and click on next. They will ask you to verify your account.
12. Now, connect your mobile and PC again. Then open the Atozflashfile.com..
13. You will see some information about your mobile phone and the operating system.
14. Click on remove FRP. The lock will be removed in a short time.
15. Congratulations, you have successfully bypassed the FRP lock.

• right-click to "Open as Administrator"

Follow these steps to enter Download Mode/Odin Mode

1. Power off your device
2. Press and hold Volume Down key, Home Key and Power Key
3. When your device vibrates, release Power key while keep holding the Volume Down key and the Home key
4. Press Volume Up key to enter Download mode, which has a green robot figure and “Downloading… Do not turn off target!!)

Your device should be automatically recognized by Odin. At the lower-left of Odin interface, it should show a message that says "Added!" and in the meantime, you should see a light-blue box at the ID: COM section stating "COM:3" (the number depending on which USB port you have plugged the device cable and is irrelevant).

Whether it is "PDA" or "AP" depends on the version of Odin that you used. But the md5 file goes to either BL"AP"CP"CSC

After adding the file, click "Start" to begin the flashing process

Click "Start" to flash.

DO NOT REMOVE OR OPERATE ON YOUR DEVICE UNTIL FINISHED OR FAILED IS SHOWED ON ODIN.

When the flashing process is done and if everything goes well, you should see a big green box saying "RESET" or "PASSED" (depends on the version of Odin is used). By now, the device should be rebooted and it is safe to remove/unplug your device

Flash succeeded

Samsung A320F Remove Screen Lock Without Data Loss File Link Samsung SM-A320F Galaxy A3 Binary U4 Repair Flash File Firmware Link Samsung SM-G970U Galaxy S10e Repair Flash File Firmware Link Samsung SM-G977U Galaxy S10 5G Combination Firmware File Link

Samsung SM-T825 Tab S3 Binary U3 Combination File

Download Link:: Link